State sync mainnet

Mainnet only

The following seed nodes are to be used when configuring a full node for the mainnet. If you are looking for testnet seed nodes, please refer to this instead.

In order to use this feature, you will have to edit a couple of things inside your ~/.desmos/config/config.toml file, under the statesync section:

1. Enable state sync by setting enable = true;

2. Set the RPC addresses from where to get the snapshots using the rpc_servers field.
   You can ask inside our discord for them.

3. Get a trusted chain height, and the associated block hash. To do this, you will have to:

   • Get the current chain height by running:

     curl -s <rpc-address>/commit  | jq "{height: .result.signed_header.header.height}"

   • Once you have the current chain height, get a height that is a little bit lower (200 blocks) than the current one.
     To do this you can execute:

     curl -s <rpc-address>/commit?height=<your-height> | jq "{height: .result.signed_header.header.height, hash: .result.signed_header.commit.block_id.hash}"
     
     # Example
     # curl -s https://rpc-desmos.itastakers.com/commit?height=100000 | jq "{height: .result.signed_header.header.height, hash: .result.signed_header.commit.block_id.hash}"

4. Now that you have a trusted height and block hash, use those values as the trust_height and trust_hash values. Also, make sure they're the right values for the Desmos version you're starting to synchronize:

   State sync height range	Desmos version
   0 - 1149679	v1.0.1
   1149680 - 1347304	v2.3.0
   > 1347305	v2.3.1

Here is an example of what the statesync section of your ~/.desmos/config/config.toml file should look like in the end (the trust_height and trust_hash should contain your values instead):

enable = true

rpc_servers = "rpc-desmos.itastakers.com:26657,135.181.60.250:26557"
trust_height = 139142
trust_hash = "F55CA4C56CAC348E453A38D6BEBD70B1CD92F7431214AE167B09EFDA478186BE"
trust_period = "336h0m0s"